When "Fake it" is selected the WSJT-X rig control indicator shows green and an S but the rig does not actually change frequency on transmit although the frequency indicator in WSJT-X does show a frequency change (rig does not change frequency) This happens when using Ham Radio Deluxe connected to the rig, selecting "Ham Radio Deluxe" in WSJT-X for the Rig and using "Rig" for split operation. It will momentarily work (rig in split and WSJT-X rig control indicator green with an S) but will drop out of split both on the rig and the indicator in WSJT-X after a second or two (and after first transmit.) "Rig controlled split operation does not work for a TS-590SG using Ham Radio Deluxe. In fact i have a very same problem as is in this link: I'm using Ham Radio Deluxe as a rig in the wsjt-x. Rig is on the table all working fine except wsjt-x and Split operation - fake it. Thanks for any insight on this small issue for a great piece of software. Source: Rear/DataMode: USBSplit Operation: Rig Tab:Â Rig:"Ham Radio Deluxe"Poll Interval: 1sPTT Method: CATTransmit Audio This also occurs with prior versions of WSJT-X and HRD.Ĭurrent Setup:WSJT-X v1.8.0-rc1Rig: Kenwood TS-590SGHam Radio DeluxeĦ.4.0.664Rig connected to computer via USB portWSJT-X settings on the Radio
When WSJT-XĬonnects directly to the rig split functions properly. Â The issuesĪrises only when WSJT-X connects through Ham Radio Deluxe. TS-590SG all works as it should (split functions properly). When HRD is disconnected and WSJT-X rig control is set to the Kenwood When "Fake it" is selected the WSJT-X rig control indicator shows greenĪnd an S but the rig does not actually change frequency on transmitĪlthough the frequency indicator in WSJT-X does show a frequency change "Ham Radio Deluxe" in WSJT-X for the Rig and using "Rig" for split This happens when using Ham Radio Deluxe connected to the rig, selecting The indicator in WSJT-X after a second or two (and after first transmit.) Indicator green with an S) but will drop out of split both on the rig and It will momentarily work (rig in split and WSJT-X rig control "Rig controlled split operation does not work for a TS-590SG using Ham In fact i haveĪny thoughts about this, and how the solve problem Rig is on the table all working fine except wsjt-x and Split operation -įake it.